[. . . ] W 300 IEM SR 350 IEM Instructions for use Contents Important safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 The ew 300 IEM G2 systems . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 The channel bank system . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Delivery includes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Note: For accupack operation of the receiver, only use the BA 2015 accupack In order to ensure optimum operational reliability. The accupack is fitted with an integrated sensor which is ­ via a third contact ­ monitored by the electronics of the receiver and the charger. The sensor is necessary for the following control purposes: The taking into account of the different voltage characteristics of primary cells (batteries) and accupacks. The battery status indications on the displays, the transmission of transmitter battery status information to the rack-mount receivers and the switch-off thresholds at the end of the operating time are corrected correspondingly. Due to the missing sensor, individual rechargeable battery cells will not be identified as accupacks. The monitoring of the accupack temperature during charging in the L 2015 charger. The prevention of improper charging of inserted primary cells (batteries). Due to the missing sensor, individual rechargeable battery cells will also not be charged in the L 2015 charger. 17 Connecting the headphones CAUTION!Listening at high volume levels for long periods can lead to permanent hearing defects. Set the volume for the connected headphones to the minimum before putting the headphones on. For monitoring purposes, connect the supplied earphones or any Sennheiser stereo headphones with 3. 5 mm stereo jack plug to the headphone output (PHONES) ³. First, set the volume control · to the lowest volume by turning it to the left as far as possible. Then gradually turn up the volume. ³ · Using the components Switching the components on/off Switching the transmitter on/off Press the ON button ¶ to switch the transmitter on. To switch the transmitter off, press the ON button until "OFF" appears on the display. Note: The transmitter can only be switched off when the standard display is shown on the display panel. Within the operating menu, the ON button serves as the ESC (cancel) key, i. e. To disconnect the transmitter from the mains, pull out the mains connector from the wall socket!Switching the receiver on/off To switch the receiver on, turn the volume control clicks. clockwise until it counterclockwise ¶ » Note: The receiver has a short switch-on delay. Remove the batteries or the accupack when the receiver will not be used for extended periods of time. 18 Adjusting the volume CAUTION!Listening at high volume levels for long periods can lead to permanent hearing defects. Set the volume for the connected headphones to the minimum before putting the headphones on. · » You can adjust the volume at the headphone output on both the transmitter and the receiver. [. . . ] No other warranty claims or claims over and above the rights stated in these terms and conditions will be accepted. Consumers may be entitled to statutory rights in their own countries which are not restricted by these warranty terms and conditions, as the warranty is governed by the laws of the country in which the Sennheiser product was purchased by the consumer. The provisions of the UN Convention on the International Sale of Goods do not apply to this service. If you wish to file a claim under the warranty, please send the product to your local service partner, together with accessories and proof of purchase. [. . . ]